Hi,
I've been using a few different laser cutters for year whilst I was Teaching. I've just bought my own LS6090 Pro 80w machine. I mainly cut 3 or 5mm acrylic and 3 & 6mm Plywood, possibly a MDF on occasion.
I have a few questions already... I suppose I post them separately - never used a forum before like this one. But I did read the intro and FAQ's which suggests my first post is a "Hello!"
Newbie in the midlands
-
- Posts: 19
- Joined: Wed Nov 09, 2016 1:03 pm
- Contact:
Newbie in the midlands
Katie S
LS6090 80W
LS6090 80W
Re: Newbie in the midlands
Hi Katie,
Welcome
Yes it helps to post individually to avoid the thread becoming confusing
Also help if you mention what machine and tube you have (or put it in your signature (in settings) as this saves us looking back or guessing
Best
Dave
Welcome
Yes it helps to post individually to avoid the thread becoming confusing
Also help if you mention what machine and tube you have (or put it in your signature (in settings) as this saves us looking back or guessing
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 1 guest