Hi to all

Koshi · Post by **Koshi** » Sat Jul 14, 2012 1:20 pm

Hi to all,

Been ready the forums for a couple of months.
Just got access.
I have found the information very useful.
Hope not to need any problems solving. (But I will )
Chris has been handy for the little hiccups of a new user on a LS6040Pro
I did recommend the 6840, After ready the advice given. But was over ruled (Not my pocket)
The 6040 is a nice tool and I’ve been playing with it for about a month now.
Look forward to getting More done instead of making scrap.

Regards Colin

PhillyDee · Post by **PhillyDee** » Sat Jul 14, 2012 4:09 pm

Welcome!

Trust me, you will never stop making scrap . . . .

Koshi · Post by **Koshi** » Fri Jul 20, 2012 12:13 pm

LOl
Yes PhillyDee.
I now spend my time thinking of how I can use the scrap bits I make

PhillyDee · Post by **PhillyDee** » Fri Jul 20, 2012 1:52 pm

Heh. I have drawers full of bits which have clear pieces in the middle I can use up.

avalonman · Post by **avalonman** » Sat Aug 04, 2012 1:17 am

i have an open file, guess where my scrap goes

Laserscript user forum

Hi to all

Hi to all

Re: Hi to all

Re: Hi to all

Re: Hi to all

Re: Hi to all

Who is online