ENGRAVING AND ETCHING BRASS
-
- Posts: 2
- Joined: Thu Jan 08, 2015 2:47 pm
- Contact:
ENGRAVING AND ETCHING BRASS
Hi, we are new to the Laser side of the business, and have just purchased a 80 watt machine. i was wondering if it was possible to engrave on brass using the black etching paint. I understand you can with stainless and anodized ally. Any help would be great. Thanks
Re: ENGRAVING AND ETCHING BRASS
Not reliably, Brass is a terrible substrate to work with, it corrodes very quickly in air and thermark / cermark etc doesn't take very well due to the copper content. It will look great to start then rub off quite quickly.
cheers
Dave
cheers
Dave
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Dave@OpticalPower.co.uk
Dave@OpticalPower.co.uk
-
- Posts: 2
- Joined: Thu Jan 08, 2015 2:47 pm
- Contact:
Re: ENGRAVING AND ETCHING BRASS
ok great thanks for your help
Who is online
Users browsing this forum: No registered users and 3 guests