New LS3060 some help needed
-
- Posts: 48
- Joined: Sat Oct 16, 2010 4:10 pm
- Contact:
Re: New LS3060 some help needed
Silly question perhaps - what is the top speed of my 3060? I've been using 200 but will it go faster?
Re: New LS3060 some help needed
Off the top of my head Rob I believe it's 500, (speed is usually MM's per second)
I don't think you will get much to work at that speed but I *believe* that's the max
best wishes
Dave
I don't think you will get much to work at that speed but I *believe* that's the max
best wishes
Dave
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Dave@OpticalPower.co.uk
Dave@OpticalPower.co.uk
Re: New LS3060 some help needed
Hi Just to let you know chris is importing a .75mm equiv of Rowmark and it works !!!!
At £7.00 per 4 x 2 its a 1/4 the price another worth knowing about also he has 1.5mm laminate at 15.00 ish.
Worth a try.
BOB
At £7.00 per 4 x 2 its a 1/4 the price another worth knowing about also he has 1.5mm laminate at 15.00 ish.
Worth a try.
BOB
-
- Posts: 48
- Joined: Sat Oct 16, 2010 4:10 pm
- Contact:
Re: New LS3060 some help needed
Thanks Bob
I actually got some from him when I picked my laser up. Its a little softer that Rowmark but it is possible to get quite nice details by doing a couple of light passes rather than in one go. I need to experiment a bit more but had quite a good result with two cuts at 75 power/ 35 speed
Regards
Rob
I actually got some from him when I picked my laser up. Its a little softer that Rowmark but it is possible to get quite nice details by doing a couple of light passes rather than in one go. I need to experiment a bit more but had quite a good result with two cuts at 75 power/ 35 speed
Regards
Rob
Who is online
Users browsing this forum: Ahrefs [Bot] and 1 guest