my machine has suddenly stopped going through acrylic on a speed 12 power 98 which I have always used. I am having to drop it to an 11- or mostly 10 now to make sure it goes through on all edges! also I am now cutting 4mm MDF on a speed 9-10 (was 16 when I first got the machine)
I have had the cutter just over 2 years now and use it every single day as a full time job. When I had my service last year in September, it was still running with plenty of power and after the service the technician had it running back at a speed 14 for a while (id been using 12 for quite some time)
I am wondering if anyone else had this problem after this amount of time?
Also sometimes when it cuts (only on some areas of the bed) it burns a 'double line' on the item.
The mirrors and lense are clean.
PLEASE HELP!
ready for new bulb?
-
- Posts: 10
- Joined: Sun May 03, 2015 2:56 pm
- Contact:
Re: ready for new bulb?
I use my machines about the same - 1 year is good as far as I'm concerned. If the output coupler is clean and the mirrors are not bloomed then it is most likely the tube
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: ready for new bulb?
Hi I would suggest trying alignment first with your comment on a double line.
this will make a major difference to the power.
also check the back of the lens is clean.
hope it helps...
this will make a major difference to the power.
also check the back of the lens is clean.
hope it helps...
Personalised bike bitz,Metal marking,adhesive decals
Who is online
Users browsing this forum: No registered users and 1 guest