Hi Everyone
Hi Everyone
Just bought a HPC 3020. Huge learning curve to go through so that I can use it. I've only used a Craft Robo/Silhoutte Cameo before so big difference. Looking forward to reading the forum to get some hints and tips on how best to use the machine.
Re: Hi Everyone
Hi - welcome
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Hi Everyone
Howdy
if you've used the Cameo and similar you are more than half way there.
You'll have to learn the laser power and speed etc. but the software/design/layout will be similar.
Maybe even the same depending on how you usually design.
if you've used the Cameo and similar you are more than half way there.
You'll have to learn the laser power and speed etc. but the software/design/layout will be similar.
Maybe even the same depending on how you usually design.
Who is online
Users browsing this forum: No registered users and 1 guest