Hi All,
So l managed to install LaserCut 6.1 on my Mac using PlayonMac. worked a charm and no problems with installation at all. However, when plugging in usb and opening LaserCut, there is communication error and the laser machine isnt reconisged. The USB drivers are installed so a bit stumped as to where to go from here. I have a LS3050.
Thnx
Mac USB connection issue
-
qashifmasud
- Posts: 2
- Joined: Wed Feb 26, 2020 3:35 pm
- Contact:
Re: Mac USB connection issue
Best Call HPC to be honest 
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 2 guests