Laserscript user forum

is there anywhere I can get advanced training on my cutter? learning any shortcuts/new techniques and how to fix problems without having to call out engineers each time? just general knowledge on how the cutter works so I can problem solve a bit better on my own?

There is so much I want to do with my machine but haven't a clue how and get sick of searching for tutorials with no info!

thanks

Where are you?

You may find someone who is willing to help for a beer or two

Best
Dave

i am in dinnington near sheffield! i know my alignment is off at the moment but i dont know how to change it! last time i messed with it i messed it up!!

You are not too far from HPC - why not call and ask if you could go to them for some training?

Best
Dave