Hi there,
Does anyone know if there is a way to reset the datum position? At present the laser head sits about 12mm down from the top of the 400x680 bed. I've looked at the runners position and it could move up about 6mm. Its a problem because when i cut a full 400 deep sheet the laser hits/fires at the bed frame and causes scorching.....
Just wondered if anyone had the same problem and resolved it?
Podbox.
LS6840
Datum position reset
Datum position reset
happy LS6840 User.
Re: Datum position reset
I would imagine you would need to move the switches. Might nit be easy to do though!
http://www.tmbelectronics.com - Electronics, tools, hobby tools, power tools, and much more!
An ex LS3020 user now playing with an LS6840PRO (60W) and an LS1290PRO (80W)
An ex LS3020 user now playing with an LS6840PRO (60W) and an LS1290PRO (80W)
Re: Datum position reset
Yeah, i had thought about that, but wondered if there was a software solution rather than hardware. I say this as when the laser is going back to the datum it hits the switch then moves forward 10mm or so.
If the datum was on the switch it would be fine, but it sits forward....
If the datum was on the switch it would be fine, but it sits forward....
happy LS6840 User.
Re: Datum position reset
Thats the machines normal mode, it touches the hard stop then moves forward to prevent damage when it datums or it would slam into the hard stops.
It can be moved but you need to speak to Si or Chris and ask about it.You can do quite a bit of damage getting it wrong
best wishes
Dave
It can be moved but you need to speak to Si or Chris and ask about it.You can do quite a bit of damage getting it wrong
best wishes
Dave
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Dave@OpticalPower.co.uk
Dave@OpticalPower.co.uk
Re: Datum position reset
Hi,
Do you want to adjust the amount it moves back after touching the switches?
This is done from the syscfg file in your c drive in the lasercut folder.
Quite complex and Chris at HPC 07854 161710 told me how to do it we wanted a jig and it to always start in the position we set after datum.
Give him a call preferably when youre at the pc
Do you want to adjust the amount it moves back after touching the switches?
This is done from the syscfg file in your c drive in the lasercut folder.
Quite complex and Chris at HPC 07854 161710 told me how to do it we wanted a jig and it to always start in the position we set after datum.
Give him a call preferably when youre at the pc
Personalised bike bitz,Metal marking,adhesive decals
Re: Datum position reset
Cheers man,
i'll do that next week when im back in the workshop.
Alan.
i'll do that next week when im back in the workshop.
Alan.
happy LS6840 User.
Who is online
Users browsing this forum: Bing [Bot] and 1 guest